Oxygen Analyzer for fast response and research applications.
The Model O2 is a versatile research grade oxygen analyzer for measuring 5-100% oxygen concentrations. The unit includes an integrated gas sampling pump, flow controller, bright LED display for oxygen concentration and status indication, touch panel controls for ease of operation, 0-1Volt DC analog and a terminal strip with relay outputs and a 4-20ma analog output, a separate digital RS-232 output, and Luer type front panel connection for response times. The front panel allows control of flow, alarm set-points, calibration, and other user features. The Model O2 can be used in research and other applications, but not approved for human medical use or diagnostics. ...
The O2Cap family integrates an Oxigraf oxygen sensor with a NDIR CO2 sensor for dual gas measurements for research, industrial and laboratory measurements. Measure Oxygen concentrations from 5-100% and CO2 from 0-10%. Perform capnography tests with fast breath by breath measurement. The units come with a pump for gas sampling system, bright vacuum fluorescent alphanumeric display (VFD), touch panel keypad, a rear 0-1VDC analog output for O2 readings, and either a rear terminal strip with limit detection relays and 4 – 20 mA analog outputs or a second CO2 analog output, and a RS232 digital interface.
The model O2Cap and O2CapB have luer type front panel gas sample input fitting for research applications. The model ...
The Models O2C, O2D and O2DAL are general purpose oxygen analyzers for research, air separation monitoring, and industrial monitoring applications. Designed to measure oxygen in a range of 5-100% accurately and in the presence of other gasses such as including Ar, He, H2, CO2 and non-condensing H2O vapors. The Model O2C features an internal pressure regulator to connection to 1-75 psig source and the Model O2D features a sampling pump for flow control. The Model O2DAL features a high flow micro pump for low pressure operation from 1200 to 55mbar (0-60,000 feet altitude).
Overlay and Sparge Gas Controller for Bioreactors.
The Model O2MIX gas mixer measures the oxygen and CO2 concentration in a gas sample inside instrument and uses this as feedback to control three (3) proportional valves to blend gasses from the three (3) inputs to a single output. The product uses feedback from actual gas measurements as a control point and different mixture and blends of gasses can be used to feed three (3) inputs for mixing. In normal operation the O2MIX is designed to accept Oxygen, Nitrogen (or Compressed “Air”) and CO2 as inputs, and a single blended output of a programmed mixture is produced by the unit to feed a Bioreactor.
The Model O2T and O2TR are oxygen analyzers for medical oxygen trans-filling and verification and designed for measuring 5-100% oxygen in nitrogen. These units are easy to use and feature bright LED displays, touch panel controls, easy calibration, a sample pump or regulator for flow control depending on model, and CPC front panel fittings. The Model O2T has a built-in sampling pump with flow from 0-250ml/minute. The Model O2TR has a built in regulator for flow control and features a simplified two (2) point calibration control on the front panel.
Based on the Oxigraf Model O2Cap Oxygen and CO2 analyzer, the O2Bio is specifically designed to provide gas monitoring of Bioreactor headspace and off-gas streams. The unit will measure continuously from an off-gas vent or periodically via a gas sample valve to take small 10-15ml samples from the bioreactor headspace via keypad or digital interface control.
The O2Bio integrates an Oxigraf tunable diode laser (TDL) oxygen sensor and a non-dispersive infrared (NDIR) CO2 sensor with a pump regulated gas sampling system. The analyzer features a bright vacuum fluorescent alphanumeric display (VFD), touch panel keypad, a rear 0-1VDC analog BNC output for O2 readings, rear terminal ...
650.237.0155
E-Mail
